Setup Guide

Instructions:
 
  1. Insert the chest strap through the metal loop
  2. Attach the chest strap onto its own velcro lining. Note: Please do not attach the chest strap to the side velcro where the name patches are attached to
  3. Unbuckle the girth (belly) strap
  4. Slide HarnessBuddy over your dog's head and buckle up the girth (belly) strap, keep it loose enough that you can easily insert 2 fingers
  5. Adjust the chest strap if it is too tight or too loose, make sure that you can also insert 2 fingers easily 
  6. Attach name patches, one on each side of the harness
  7. Woof, woof! Let's go and have some walk!

Still don't get it? Simply check out the short videos below: